dma crc error count and disabled Parity Drive


Recommended Posts

Hello,

 

i got some "dma crc error count" and then my Parity Drive was disabled.

 

The only thing i did, is disconnecting an 2TB Unassigned Disc and changed it against a 4TB one on the same port. Then started the backups script from this thread:

 

Diagnostic is attached.

 

Is there a way to bring my Parity Drive back online, without using "new config"?

 

I hope, you can help me. Thank you.

 

unraid-1-diagnostics-20210603-2003.zip

Link to comment
10 minutes ago, mgutt said:

How is the parity drive connected? Possible to swap the cable?

Parity Drive is connected to an HBA: IBM ServeRaid M1015 SATA / SAS HBA Controller (IT Mode) with a Mini SAS 36 Pin-Stecker (SFF-8087) to 4 x SATA

i can swap from P00 to P01 on the HBA

when i installed this, i was very carefully and this worked since february 

 

what is the best way, to bring my parity back online?

Edited by sonic6
Link to comment
25 minutes ago, sonic6 said:

what is the best way, to bring my parity back online?

From my understanding, Unraid only disables a drive when it cannot write to it.

So, if it was disabled, the content of your Parity drive is probably out of sync with the Array.

You could do a new config and say that Parity is valid, but it is probably not.

 

Let's see what our more experienced users think of that.

  • Thanks 1
Link to comment

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.