mustava Posted June 4, 2021 Share Posted June 4, 2021 Hi All, I recently swapped my CPU over to a higher model. Upon reboot of Unraid, one of my disks became disabled. Initial inspections of the disk, it appears healthy? I am unsure of the process to re-enable this drive? do I have to rebuild it? is there anyway to re-enable it without a rebuild? Appreciate any advice! tower-smart-20210604-0117.zip Quote Link to comment
JorgeB Posted June 4, 2021 Share Posted June 4, 2021 SMART looks mostly OK, but you should post the complete diags, hopefully you didn't reboot yet, much more info there. Quote Link to comment
mustava Posted June 4, 2021 Author Share Posted June 4, 2021 6 minutes ago, JorgeB said: SMART looks mostly OK, but you should post the complete diags, hopefully you didn't reboot yet, much more info there. I did reboot Quote Link to comment
JorgeB Posted June 4, 2021 Share Posted June 4, 2021 Then not much more we can say for now unless you have some controller that's is known to have issues, you can run an extended SMART test on the disable disk and if it passes rebuild on top, before doing that you can also replace/swap cables to rule them out if it happens again to the same disk. Quote Link to comment
mustava Posted June 5, 2021 Author Share Posted June 5, 2021 14 hours ago, JorgeB said: Then not much more we can say for now unless you have some controller that's is known to have issues, you can run an extended SMART test on the disable disk and if it passes rebuild on top, before doing that you can also replace/swap cables to rule them out if it happens again to the same disk. If I assume the disk is fine, is there a way i can add it back to the array without rebuilding? Quote Link to comment
trurl Posted June 5, 2021 Share Posted June 5, 2021 Post diagnostics for further advice. Quote Link to comment
mustava Posted June 5, 2021 Author Share Posted June 5, 2021 31 minutes ago, trurl said: Post diagnostics for further advice. Attached tower-diagnostics-20210605-1113.zip Quote Link to comment
trurl Posted June 5, 2021 Share Posted June 5, 2021 Why did you run filesystem check on the disk? That won't help with disabled but it will help with unmountable. Was the disk both unmountable and disabled? The emulated disk seems to be mounted now and doesn't look like anything wound up in lost+found share. You will have to rebuild because the disk is no longer in sync with the array. The only alternative to get the array back in sync is New Config and rebuild parity, but it is the data disk that really needs to be rebuilt. Have you checked the contents of the emulated disk? The contents of the emulated disk is what will result from rebuild. Since you rebooted syslog doesn't tell us why the disk was disabled. Looks like you are using Marvell controller, these are not recommended. Are you running Unraid virtually? You seem to have omitted that crucial information in your description. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.