July 27, 20214 yr Hi, i installed dual nic card in my board both nics are online and working. When i try to add it the passthrough device under system devices the checkbox is greyed out. Any ideas why? there is a error in the log. Sounds like it can;'t load the card into the system I am running unraid version 6.9.2 and i believe i had this working in the old version by manually editing the file but i think i removed those entries since it was no longer needed.
July 27, 20214 yr Author If i set the ACS to both i can passthrough the one nic from the dual gigabit nic. I am not sure why its not letting select both
July 27, 20214 yr Author 6 hours ago, ghost82 said: maybe one is in use by unraid? I forgot to mention. I have 3 nics. Unraid is plugged into the build in Nic. These nics aren't being used for anything. I do see it show up in the unraid network setting so it is being detected.
July 27, 20214 yr Usually, If you have settings under Unraid for the NIC, then Unraid won't allow to pass it through. Double check the network/VM/Docker settings.
July 27, 20214 yr Author 5 hours ago, Vr2Io said: Usually, If you have settings under Unraid for the NIC, then Unraid won't allow to pass it through. Double check the network/VM/Docker settings. Good call on that, i noticed Eth1 had bridging enabled,. I was able to pass through both devices now. Its now working!
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.