I have a scenario where I have to change from the "default" settings on the spin up and spin down settings when you click into a disk. Same things for SMART test controller. I change the settings and then once I go back into their they are set back to say "Default". I have clicked apply in that specific section the settings applies to. I have then tried clicking "done" and also just going back to the main tab. If they do persist, it is only for a few minutes/hours and then they seem to revert back to say "Default".

 

Any ideas? 

 

Edit: I'm usually trying to change these when the array has already been started.

Edited September 1, 20214 yr by live4soccer7

It's a known issue with v6.9.x, should be fixed on v6.10-rc1

Any major issues with v6.10-rc1? I'm kind of needing that to work to help report issues with disks from smart reports.

1 hour ago, live4soccer7 said:

Any major issues with v6.10-rc1?

Not that I know of, just make sure user shares are still enable after updating.