live4soccer7 Posted September 1, 2021 Share Posted September 1, 2021 (edited) I have a scenario where I have to change from the "default" settings on the spin up and spin down settings when you click into a disk. Same things for SMART test controller. I change the settings and then once I go back into their they are set back to say "Default". I have clicked apply in that specific section the settings applies to. I have then tried clicking "done" and also just going back to the main tab. If they do persist, it is only for a few minutes/hours and then they seem to revert back to say "Default". Any ideas? Edit: I'm usually trying to change these when the array has already been started. Edited September 1, 2021 by live4soccer7 Quote Link to comment
JorgeB Posted September 1, 2021 Share Posted September 1, 2021 It's a known issue with v6.9.x, should be fixed on v6.10-rc1 Quote Link to comment
live4soccer7 Posted September 1, 2021 Author Share Posted September 1, 2021 Any major issues with v6.10-rc1? I'm kind of needing that to work to help report issues with disks from smart reports. Quote Link to comment
JorgeB Posted September 1, 2021 Share Posted September 1, 2021 1 hour ago, live4soccer7 said: Any major issues with v6.10-rc1? Not that I know of, just make sure user shares are still enable after updating. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.