This AM I noticed two dockers quit running over night. I would get Execution Error 403.  I googled around a bit and it seems that my docker image was corrupted.  So I followed the instructions to recreate it and re-install all my previous dockers.

 

It never returned from a installing that last docker so the prompt/log window never went away.

 

I rebooted the server and when it came back up it started a parity check which I have paused.

 

I was able to start the first two dockers, then hit run all.  Now it is just hanging and nothing is starting.

 

Not sure what is going wrong, but here are my diagnostics.

 

thanks,

david

tower-diagnostics-20211017-1118.zip

Your Unassigned device (WD-WCC4M3359195) is having a heart attack and needs to be replaced.

 

  1 Raw_Read_Error_Rate     POSR-K   200   200   051    -    3029
  3 Spin_Up_Time            POS--K   199   170   021    -    3033
  4 Start_Stop_Count        -O--CK   096   096   000    -    4878
  5 Reallocated_Sector_Ct   PO--CK   200   200   140    -    0
  7 Seek_Error_Rate         -OSR-K   200   200   000    -    0
  9 Power_On_Hours          -O--CK   050   050   000    -    37077
 10 Spin_Retry_Count        -O--CK   100   100   000    -    0
 11 Calibration_Retry_Count -O--CK   100   100   000    -    0
 12 Power_Cycle_Count       -O--CK   100   100   000    -    123
192 Power-Off_Retract_Count -O--CK   200   200   000    -    68
193 Load_Cycle_Count        -O--CK   076   076   000    -    372728
194 Temperature_Celsius     -O---K   116   109   000    -    31
196 Reallocated_Event_Count -O--CK   200   200   000    -    0
197 Current_Pending_Sector  -O--CK   200   200   000    -    11
198 Offline_Uncorrectable   ----CK   200   200   000    -    11
199 UDMA_CRC_Error_Count    -O--CK   200   200   000    -    0
200 Multi_Zone_Error_Rate   ---R--   198   198   000    -    906

Raw Read Error Rate should be always at 0 on WD drives

 

This is presumably where your docker.img is mounted and is odds on the root of all your problems.

I was just posting that I see that sdi is gone.  Yes that is where my docker.img is stored along with all my dockers.

 

So how best to recover?  Two days ago I installed the new version of the docker backup script and did a complete backup to disk7.

 

I moved all my dockers from my cache drive because I had swapped it to an SSD and it was getting an insane number of writes.

 

How would you recommend me recovering?  As I installed docker when it first came out, I've not kept up on what is the recommended way to do it any longer.  Back then you couldn't have it on in share on the array.  Is that still the case?

 

thanks

I had a second 2TB drive I had installed to make a pool for my docker stuff. I just brought that online and it all worked as planned.

 

thanks