Hi Guys,

 

Just built a new server with 2 10Gb networks cards

 

HPE Ethernet 10Gb 2-port 530SFP+ Adapter
HPE Ethernet 10Gb 2-port 530T Adapter (RJ45 copper)

 

The 530T works great but the 530SFP+ will not light up when connected, does Unraid have built in drivers for it?

 

If not how would I go about adding them?
 

The Card:
https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_na-c03354448

 

The server is a ML350 G9.

 

Running latest unraid.

9 minutes ago, AVID said:

HPE Ethernet 10Gb 2-port 530SFP+ Adapter

Do you see a driver on card if you do lspci -v 

 

04:00.0 Ethernet controller: Intel Corporation Ethernet Controller I225-V (rev 03)
        Subsystem: Micro-Star International Co., Ltd. [MSI] Device 7d25
        Flags: bus master, fast devsel, latency 0, IRQ 18, IOMMU group 14
        Memory at 52500000 (32-bit, non-prefetchable) [size=1M]
        Memory at 52600000 (32-bit, non-prefetchable) [size=16K]
        Capabilities: [40] Power Management version 3
        Capabilities: [50] MSI: Enable- Count=1/1 Maskable+ 64bit+
        Capabilities: [70] MSI-X: Enable+ Count=5 Masked-
        Capabilities: [a0] Express Endpoint, MSI 00
        Capabilities: [100] Advanced Error Reporting
        Capabilities: [140] Device Serial Number d8-bb-c1-ff-ff-8c-c9-b0
        Capabilities: [1c0] Latency Tolerance Reporting
        Capabilities: [1f0] Precision Time Measurement
        Capabilities: [1e0] L1 PM Substates
        Kernel driver in use: vfio-pci
        Kernel modules: igc

Edited November 28, 20214 yr by SimonF

Thanks @SimonF I'm not at the server right now and it does not yet have WAN access due to a faulty underground cable, I'll run the command as soon as im near the server.

 

Edited November 28, 20214 yr by AVID

@SimonF OK, thanks for that command, it was detected and I just needed to figure out what ethernet adapter number it was and enable it.

 

Both the 530SFP+ and 530T show up as 10000mbps