Adding a new drive to array

[Kishin]

Hello,

 

i'm trying to add a 12Tb disk to an array constitued with 1 parity of 14Tb and 2 HDD of 14Tb.

 

So i stop the array, select the disk but then it dissapears from the list without adding it.

I noticed that the device name changed from dev 1 to sde (which is the next name of my array sdb,sdc,sdd)

 

Thanks,

Kishin.

 

 

[itimpi]

You are likely to get better informed feedback if you post your systems diagnostics zip file

[Vr2Io]

You connect the 12TB disk by USB ?

[Kishin]

@itimpiOh yes, my bad, here is my nas diagnostics

@Vr2Io No its inside the case connected by SATA. (its a shuckable drive)

 

 

nas-diagnostics-20211205-0951.zip

[Vr2Io]

Disk / SATA link have repeat error, I have two new shuck 12TB disk (WDC_WD120EDBZ-11B1HA0) in same model, but no problem.

 

Dec  5 08:31:27 NAS kernel: ata4.00: failed to enable Sense Data Reporting, Emask 0x1
Dec  5 08:31:27 NAS kernel: ata4.00: ATA Identify Device Log not supported
Dec  5 08:31:27 NAS kernel: ata4.00: Security Log not supported
Dec  5 08:31:27 NAS kernel: ata4.00: configured for UDMA/133 (device error ignored)
Dec  5 08:31:27 NAS kernel: ata4: EH complete
Dec  5 08:31:27 NAS kernel: ata4.00: exception Emask 0x0 SAct 0x0 SErr 0x0 action 0x0
Dec  5 08:31:27 NAS kernel: ata4.00: irq_stat 0x40000001
Dec  5 08:31:27 NAS kernel: ata4.00: failed command: READ DMA
Dec  5 08:31:27 NAS kernel: ata4.00: cmd c8/00:08:00:10:09/00:00:00:00:00/e0 tag 3 dma 4096 in
Dec  5 08:31:27 NAS kernel:         res 51/04:08:00:10:09/00:00:00:00:00/40 Emask 0x1 (device error)
Dec  5 08:31:27 NAS kernel: ata4.00: status: { DRDY ERR }
Dec  5 08:31:27 NAS kernel: ata4.00: error: { ABRT }
Dec  5 08:31:27 NAS kernel: ata4.00: supports DRM functions and may not be fully accessible
Dec  5 08:31:27 NAS kernel: ata4.00: NCQ Send/Recv Log not supported

 

Edited December 5, 2021 by Vr2Io

[Kishin]

Hum, what could be a solution to it ? I tried 2 other SATA link, one didnt show the disk and the other one had the same problem.

 

I can format it but still same problem after..

 

[Vr2Io]

May be power issue, try disable array auto start, then disconnect some disks, never new-config, format, start array ...... until you found 12TB disk been stable and no more alarm prompt out.

 

Then let us know what make alarm gone.

Edited December 6, 2021 by Vr2Io