December 10, 20214 yr I have been running 6.5.3 without any problems for some time. Tried to update to 6.9.2 to use new plugins and dockers that are not compatible with 6.5.3. However, after 6.9.2 boots following update, it cannot see any of my HDD in the GUI and I cannot start the array. Any help is appreciated. Diagnostics zip is attached. cube-diagnostics-20211210-1616.zip
December 10, 20214 yr Community Expert Can you see the drives in the BIOS? Have you tried booting in SAFE mode?
December 10, 20214 yr Community Expert 01:00.0 SATA controller [0106]: Marvell Technology Group Ltd. 88SE9230 PCIe 2.0 x2 4-port SATA 6 Gb/s RAID Controller [1b4b:9230] (rev 11) Subsystem: Marvell Technology Group Ltd. 88SE9230 PCIe SATA 6Gb/s Controller [1b4b:9230] Kernel driver in use: ahci Kernel modules: ahci Marvell controllers are NOT recommended but some are able to use them by disabling IOMMU in BIOS. Are any of the disks on your other controller?
December 11, 20214 yr Author Thank you for your insight. I need to pass through a USB Soft modem to a VM so I think I need IOMMU enabled, correct? I will also have to check other SATA controller on system. In the meantime I had to restore back to 6.5.3 to get everything running again. Thanks again
December 11, 20214 yr Community Expert Problem is the Marvell controller, this sometimes help, or better yet replace it with one of the recommended models.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.