comet424 Posted December 26, 2021 Share Posted December 26, 2021 so i had a 2tb nvme i was upgrading too.. i had moved the unraid files to the array... shut it down shoved the nvme in and booted up and it didnt work gui wouldnt work.. but i could ssh in.. i know before if i pull all the hard drives out and then boot up usually fixes it.. and its set automounting off but it also wont mount the drives if i change the disk.cfg to yes i dont have a video card right now plugged into server to check.. is there a diagnostic log you can get from command line? Quote Link to comment
itimpi Posted December 26, 2021 Share Posted December 26, 2021 You can use the diagnostics command Quote Link to comment
comet424 Posted December 26, 2021 Author Share Posted December 26, 2021 so disk.cfg will say yes for automount as i was retying... and all the disks are pulled out so probably say no disks installed cant figure why it wont give the gui.. so gui wont work.. and automount will not mount the drives either.. tower-diagnostics-20211226-1119.zip Quote Link to comment
comet424 Posted December 26, 2021 Author Share Posted December 26, 2021 (edited) still havent gotten it up and running yet... i guess i can try pulling out the nvme to see if that helps update: the gui will show up if i pull out the nvme.. but wont boot with it in there.. does the logs say its bad or something? Edited December 26, 2021 by comet424 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.