dcruff Posted January 6, 2022 Share Posted January 6, 2022 My new Unraid installation keeps freezing up. Sometimes during an operation copying files, other times while just sitting there doing nothing and only after a couple of hours of uptime. Is there a log file that I should look at for clues? Quote Link to comment
trurl Posted January 6, 2022 Share Posted January 6, 2022 Post diagnostics, then setup syslog server Quote Link to comment
dcruff Posted January 6, 2022 Author Share Posted January 6, 2022 Interesting, but when I set up the syslog server, then pressed APPLY, my screens when blank - meaning that the GUI header is still there and I can select any of the Primary tabs, but there is nothing on the screen below. However, my Emby server is still running and functional, so it is not a 'freeze'. Apparently, I'll have to reboot - again. Here's the diagnostics data: embyserver-diagnostics-20220106-1437.zip Quote Link to comment
dcruff Posted January 6, 2022 Author Share Posted January 6, 2022 I've now rebooted and the syslog server has been setup and applied.. I even setup a copy to the flash drive. I'll have more data the next time I get a freeze. Quote Link to comment
dcruff Posted January 13, 2022 Author Share Posted January 13, 2022 Is there anyone available who can take a stab at this? My Unraid Server needs a hard reboot at least every day. Sometimes after only a few hours. embyserver-diagnostics-20220113-1547.zip Quote Link to comment
trurl Posted January 13, 2022 Share Posted January 13, 2022 Checksum errors on cache, often a RAM problem. And bad RAM can cause lots of other problems. Have you done memtest? Quote Link to comment
dcruff Posted January 14, 2022 Author Share Posted January 14, 2022 I actually just went into my shares and turned the cache to "no" for everything to see if that helps. Now, I'm reading up on how to do memtest. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.