January 29, 20224 yr This pluggin is not using the eth0 but (main system) rather eth1 which is not the segment I want it using. How do I chage that, as I do not see that in the gui. UnRaid v6.9.1
January 29, 20224 yr The plugin is going to to use the same NIC / ethernet rules etc that the OS itself uses.
January 29, 20224 yr Author ok. The OS uses the "default" route? If so how does one change that default route? Thanks for the quick reply.
March 16, 20224 yr i have a similar issue. I have both eth0 and eth1 configured because my host is attempting to provide service to a VLAN that is otherwise not visible to other parts of my network. The address I wish myservers to use is the local address of eth1 but instead, it's putting the local address of eth0 in the DNS entry at unraid.net. I have IPv4 default gateway metrics set so that eth1 is a higher priority (lower) metric (metric 1) than eth0 (metric 2). route table confirms this too. traceroute on the unraid host shell shows traffic exiting eth1 confirming that the default route is going via eth1. not sure how the plugin decide what interface's address to use. does it just always pick eth0?
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.