cpublik Posted May 6, 2022 Share Posted May 6, 2022 I had a 2TB drive that was reporting errors, so I replaced it with another 2TB, but the parity sync is now going extremely slowly, ~250 KB/sec.. I looked through the syslog and didn't see anything that jumped out at me.. diagnostics are attached. Any ideas greatly appreciated. publik-unraid-diagnostics-20220506-0036.zip Quote Link to comment
JorgeB Posted May 6, 2022 Share Posted May 6, 2022 Onboard SATA is set to IDE, change to AHCI and try again. Quote Link to comment
cpublik Posted May 6, 2022 Author Share Posted May 6, 2022 Thanks.. don't know how I didn't notice it was set that way. I just changed it to AHCI though, and the sync performance is the same. Going to check again that the cables are good, etc and will report back. Quote Link to comment
Solution JorgeB Posted May 6, 2022 Solution Share Posted May 6, 2022 If it's still slow also a good idea to run a test with the diskspeed docker to make sure all disks are performing normally. Quote Link to comment
cpublik Posted May 6, 2022 Author Share Posted May 6, 2022 Update on this.. turns out the "new" drive (actually not-so-new) was no good. Put in a different one, and it's currently syncing at ~30MB/sec Thanks for the help 1 Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.