Meso Posted May 30, 2022 Share Posted May 30, 2022 I recently had usb failure and with it all the content on it. i have a backup with My Servers but its a little older and i have added a drive since that backup was made. now that i have booted up from the older backup, whenever i assign the new drive to the array, it warns me that the drive is going to be overwritten. is there a way i can add the drive back to the array without it being overwritten? i have 4 drives and 1 of them are used in parity. there were 3 drives when the backup was made and now there are 4. thanks Quote Link to comment
Solution JorgeB Posted May 30, 2022 Solution Share Posted May 30, 2022 You can do a new config then check "parity is already valid" before array start. Quote Link to comment
Meso Posted June 8, 2022 Author Share Posted June 8, 2022 Thank you! I can’t believe i didn’t think of that Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.