3 Network Adapters, Interface rules tab missing

[Nano]

I need to change ETH0 Has it changed location? I can't see the tab at all! 

 

I have stopped and started Docker, Nothing, is it possible to adjust elsewhere, Possibly on USB or Shell

[JorgeB]

What Unraid release? There were some fixes for that in v6.10.2

[Nano]

8 minutes ago, JorgeB said:

What Unraid release? There were some fixes for that in v6.10.2

6.10.2 

[JorgeB]

Then you should post the diagnostics.

[Nano]

9 minutes ago, JorgeB said:

Then you should post the diagnostics.

 

pontower-diagnostics-20220531-1152.zip

[JorgeB]

@bonienlany idea why network-rules.cfg is not being created here? The NICs are being detected.

[bonienl]

May 31 11:18:43 PonTower kernel: e1000e 0000:00:19.0 0000:00:19.0 (uninitialized): registered PHC clock

 

Normally at this point the ethernet interface is assigned, but here it fails.

I don't know if this is a driver issue, I am not using the e1000e driver.

 

Can you try without using the bond interface and use eth0 as a single interface only?

 

[Nano]

Do I need to do a clean install of Unraid here to fix it? If so is that a fairly easy process, other option is downgrade to 6.10.1

[JorgeB]

You can try with a a new clean flash drive, don't even need a key to test.

[Nano]

On 5/31/2022 at 2:44 PM, bonienl said:

May 31 11:18:43 PonTower kernel: e1000e 0000:00:19.0 0000:00:19.0 (uninitialized): registered PHC clock

 

Normally at this point the ethernet interface is assigned, but here it fails.

I don't know if this is a driver issue, I am not using the e1000e driver.

 

Can you try without using the bond interface and use eth0 as a single interface only?

 

This did not work, tried all kinds of bonding, unbonding, port downing 2/3, rebooting. nothing.

Edited June 2, 2022 by Nano

[Nano]

This *Resolved* by first downgrading to 6.10.1 that Brought back interface rules but then ETH2 MAC was showing as ETH2 and ETH3 (eth3 was not an actual adapter)

 

Removed ETH2 Card from the system and then ETH0 appeared allowing to swap ETH 1 to ETH0 as I wanted.

 

....... Fixed but not in a good or meaningful way.

[KptnKMan]

Well, looks like I might need to downgrade. ☹️

 

I'm seeing this same issue, and now I'm stuck using 6.10.2.

 

[JorgeB]

Upgrade to v6.10.3-rc1, fixed there.

[KptnKMan]

This is a nightmare, I just downgraded to 6.10.1 and the interface assignments and network-rules.cfg has reappeared but now other issues.

I'll document in the linked thread, I try not to hijack other peoples support threads with my issues.

 

Thanks for the advice.