6.9.2 > 6.10.3 Array offline and all drives unassigned

[phneutral]

What the title says - just upgraded and my array is missing all drives. When I select the correct serials from the drop down it says 'wrong' and array won't start because of this.

 

diagnostics attached. What happened?

 

Rolled back and the array is online but the docker service won't start. The error is "path does not exist" for Docker vdisk location and appdata storage. Thanks in advance!

6-9-2 no docker-myserver-diagnostics-20220915-0744.zip 6-10-3 no array-myserver-diagnostics-20220915-0737.zip

[phneutral]

OK I can see that after rolling back my cache pool drives are unassigned, how do I add these back in safely? Can't see anything on the main page 

[JorgeB]

Problem occurred because you are using a very old firmware for the LSI HBA, upgrade to latest then upgrade back to v6.10.3, do a new config, re-assign all devices as they were and check "parity is already valid"  before array start.

[phneutral]

root@MyServer:/lsi# sas3flash -o -f SAS9300_8i_IT.bin
Avago Technologies SAS3 Flash Utility
Version 17.00.00.00 (2018.04.02) 
Copyright 2008-2018 Avago Technologies. All rights reserved.

        Advanced Mode Set

        Adapter Selected is a Avago SAS: SAS3008(C0)

        Executing Operation: Flash Firmware Image

                Firmware Image has a Valid Checksum. 
                Firmware Version 16.00.10.00
                Firmware Image compatible with Controller. 

                Valid NVDATA Image found. 
                NVDATA Major Version 0e.01 
                Checking for a compatible NVData image... 

                NVDATA Device ID and Chip Revision match verified.
                NVDATA Versions Compatible.
                Valid Initialization Image verified.
                Valid BootLoader Image verified.

                ERROR: Cannot Flash IT Firmware over IR Firmware!

                Firmware Image Validation Failed! 

        Due to error remaining commands will not be executed.
        Unable to Process Commands.
        Exiting SAS3Flash.

having a bit of bother here, googling now but any ideas welcome 

[JorgeB]

1 hour ago, phneutral said:

ERROR: Cannot Flash IT Firmware over IR Firmware!

Didn't notice it was using the Raid firmware, you need to first delete that one then flash the IT, instructions should be easy to find with Google, might need to use DOS or Windows to do it, Linux SAS2FLASH doesn't work for some functions.