Prior to updating to 6.11.1 from 6.10.9 (? not sure if that was it or not, but it was the latest prior to 6.11.1) S3 plugin worked fine and I had no issues with it. Since the update, the NAS does go into sleep mode but immediately re-awakes.  I have shutdown, unplugged power and rebooted but the same issue.

 

A cursory look at Syslog seems to show this error after sleep and before re-awake...

 

NAS kernel: Freezing of tasks failed after 20.005 seconds (1 tasks refusing to freeze, wq_busy=0):

 

Any idea how to keep my server sleeping?

 

Thanks

 

EDIT: Out of interest I changed S3 to do a Shutdown instead of sleep - it worked fine.  Sleep will not work however.  Even if pressing sleep off the Main Tab.

nas-diagnostics-20221012-1309.zip

Edited October 12, 20223 yr by Bob Corless
typo and update

^

If the S3 plugin is not compatible with the new kernel on your system, you should ask on the plugin support thread.

Although I have asked the question in the Dynamix thread, I tried this command line to sleep Unraid.

 

echo -n mem > /sys/power/state

 

After a short while this message appears.

 

write error: Device or resource busy

 

Does this point to an issue other then the S3 plugin?

^

UPDATE:

Since upgrading to 6.11.5 the issue has resolved.  PC goes to sleep as it used to.  

 

So some bug fix has alos cured the S3 issue.  YAY!

On 11/22/2022 at 10:54 PM, Bob Corless said:

UPDATE:

Since upgrading to 6.11.5 the issue has resolved.  PC goes to sleep as it used to.  

 

So some bug fix has alos cured the S3 issue.  YAY!

After a reboot, problem returns.