November 13, 20223 yr I've been back and forth but haven't found a solution yet. When Unraid boots up, the array will not autostart. In settings under 'Disk settings', 'Enable auto start:' is set to Yes. Yet when the server boots up it says in the lower grey area that the array is stopped. When I look at the 'Array operation section' it shows: Stopped. However when I hover over it, it shows: I can manually start it and everything looks fine (and works). I have set 'Enable auto start' to no, rebooted and then set it to yes and rebooted again but no luck so far. The disks in the array seem to be fine... I seem to be missing something but I have no idea what... Any ideas? Edited November 13, 20223 yr by ErikH punctuation ;)
November 13, 20223 yr I’m sure I’m not the person to help with this but I would recommend you post your diagnostics from right after a reboot with the array set to auto start.
November 13, 20223 yr Author Of course, thanks! Here is my diagnostics zip-file. tower-diagnostics-20221113-1519.zip
November 13, 20223 yr Community Expert It's a known issue with v6.11.3 with a trial key, it's already been fixed and v6.11.4 should be available soon.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.