November 23, 20223 yr Upgrading from 6.9 to 6.11.5 and stuck in a boot loop now. I am able to boot into the GUI safe mode meaning it's most likely a plugin issue from what I've read, however, I have deleted all .plg files from /boot/config/plugins and am still unable to boot normally. Any suggestions would be appreciated. tower-diagnostics-20221123-1216.zip
November 23, 20223 yr Community Expert I would start by creating a new stock v6.11.5 install on a different flash drive, no key needed, just to confirm it boots in normal mode and it's some config issue.
November 23, 20223 yr Author It still loops even with the fresh install with a different usb. I guess I'll go up one release at a time until it happens again. Glad I took a backup before upgrading.
November 23, 20223 yr Author Looks like the furthest I can get is 6.11.1. Anything past that and I get the same boot loop issue. I tested this on a different flash drive using the manual upgrade method. This drive had no config on it.
November 24, 20223 yr Community Expert Can you see where in the boot process it reboots? Also safe boot still works correct?
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.