November 30, 20223 yr I had an Array of 11 2TB Drives with 2 Parity Disks Running when my Breaker tripped last night. I have not found any possible cause for the breaker tripping so my working theory is that the power to my entire house went out and the momentary surge in demand as my 2 servers and 1 drive shelf restarted after the power came back overloaded the breaker. That doesnt change my current problem though. After booting the Unraid host it wont recognize the array drives as the array drives(as shown in the picture - before today the drives did not have the _35000c... at the end) I can still tell which drive was in which place in the array but if i select the drives in the gui it just says wrong as shown in capture.png on the parity drive. Is there any other way to manually rebuild the array ?
December 1, 20223 yr Community Expert Do a new config, re-assign all drives to their original slots and check "parity is already valid" before starting the array, also recommend updating the LSI firmware to latest.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.