I am baffled and confused ......

[ahab666]

After changing my parity drives - because the last ones i used produced read errors, even though they passed the full pre-clear routine.

With the factory-new drives I did a resynch without a preclear and it seemed to work, BUT now I am getting an error notification array health report = FAIL

Can anyone explain that to me please, attached 2 files and if you need additional dumps please name them including their location(s).

 

cheers 

 

tower-diagnostics-20221204-1227.zip

Edited December 4, 2022 by ahab666

[itimpi]

Your diagnostics seem to show that parity2 has been disabled !  This would happen if a write to it failed for any reason.  Your screenshot does not show enough to confirm this and to give the serial number so we can check it’s SMART information.

[ahab666]

Sorry did not consider that .... 2nd try

[JorgeB]

See the notification details, it should have more info, possibly a device temperature issue, if a device temp is above the set warning it will be considered a fail.

[ahab666]

37 minutes ago, JorgeB said:

See the notification details, it should have more info, possibly a device temperature issue, if a device temp is above the set warning it will be considered a fail.

THX for that idea - but my server is in an unheated basement and its winter time ... even during summer HDD temperatures rarely reach 32 to 35 C .... 

 

 

cheers

[JorgeB]

55 minutes ago, JorgeB said:

See the notification details

It should show which device is the problem

[Kilrah]

When did the notification first appear? If it was while building parity that's normal as the array is considered "failed" until it's fully protected again. 

[ahab666]

Thanks - it happened either during the initial parity run or slightly afterwards .... 😄