I have had repeated issues with the Webui failing.  It typically happens when I am moving a bunch of data between disks.  After it happens I can SSH into the server but it wont power down with the command and even the diagnostic command hangs.  Eventually I lose access via SSH and if I leave it long enough I start losing access to my dockers and VM's.  The only way to get everything back up and running is to physically force a shutdown or restart.  I am hoping someone can review the diagnostics and shine some light on what the issue is.

 

Thanks,

server-diagnostics-20230107-2327.zip

Syslog in the diags starts over after every reboot, you can enable the syslog server and post that after the problem occurs again.

4 hours ago, JorgeB said:

Syslog in the diags starts over after every reboot, you can enable the syslog server and post that after the problem occurs again.

Yeah I thought that might be the case.  I am no expert on reading log files but they appeared to not go back too far.  I do have a question though on setting up a syslog server.  I enabled local syslog server and pointed it to a new share that I created but it doesn't appear to be collecting any logs.  The share is completely empty.  My understanding was that the syslogs were supposed to continuously write to the share.

Disregard.  Didn't realize you still have to set it up as a remote syslog server when you enabled the local server.  

 

Thanks i will check the logs next time this happens.

What do you get from command line with this?

df -h /