suharoba Posted February 2, 2023 Share Posted February 2, 2023 (edited) Hello, this week my procesor died and I swapped it for same one (i5 6500) in between I performe cmos clear. Before the swap and cmos clear PC would boot without monitor. Now after the change it wont boot unless I plug in montor. I looked in bios for some settings but I did not find anything that would enabled. I know that I can get hdmi dummy plug, but I would prefer to do it without (especialy because it worked before). I am using biostar TB250-BTC+ motherboard Motherboard manuals Edited February 2, 2023 by suharoba Quote Link to comment
Yankton Posted February 2, 2023 Share Posted February 2, 2023 Look for an option that is 'Halt On' with different options. Usually all errors or all errors but keyboards. Should be an option to not halt. Quote Link to comment
suharoba Posted February 2, 2023 Author Share Posted February 2, 2023 I looked but did not find any option that resembles to "Halt On". I also included motherboard manuals if you would be so kind to look over because there is all the functions that I have in bios. Quote Link to comment
suharoba Posted February 2, 2023 Author Share Posted February 2, 2023 Hello, I figured out what settings was the right one. option ROM message : Keep current Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.