Parity check just finished with 1757 errors. Attached are the diagnostics. I'd like recommendations on how to troubleshoot and proceed.

 

I don't see any write errors and all drives are XFS. I haven't done any other troubleshooting. The array seems to be working as expected.

 

Thank you for your help.

 

tower-diagnostics-20230202-1142.zip

Any unclean shutdown since the previous check? In any case first step is to run another check, it can be non correcting, to see if more errors are found.

1 hour ago, JorgeB said:

Any unclean shutdown since the previous check? In any case first step is to run another check, it can be non correcting, to see if more errors are found.

 

I don't think there was a non-clean shutdown since the last check. I did install a new drive - and there was a subsequent parity rebuild of the new drive.

I will run another check right now (non-correcting).

Thanks.

 

Edited February 2, 20233 yr by volcs0

On 2/2/2023 at 12:52 PM, JorgeB said:

Any unclean shutdown since the previous check? In any case first step is to run another check, it can be non correcting, to see if more errors are found.

 

Check just finished with 4 errors. I ran it as "non correcting."

 

Any other thoughts?

Thanks.

Post new diags.

On 2/4/2023 at 1:55 AM, JorgeB said:

Post new diags.

 

Here you go.

 

Thanks.

tower-diagnostics-20230205-1913.zip

New errors are on different sectors, but quite close to the earlier ones, which by itself is suspect and could point more to a disk problem, unfortunately if that is the problem there's no easy way to find the culprit, start by running memtest first to rule out any obvious RAM issues.