February 12, 20233 yr Hard Drive Red X - Followed Procedure to Assign Drive - No Box To Check to rebuild drive. Please advise.
February 12, 20233 yr Author I started the array after following steps outlined to replace a disk. The instructions said there should be a box in the Array Operation area. Did not see a box. It look like it rebuilding the disk. ( I hope) Looks like it going to take a long time. Also, now the disk is being written to and then makes a noise. The disk pass pre clear so I do not know why it making a noise.
February 12, 20233 yr Author Will I be able to use my unraid while the disk is being rebuild? I notice it said that the old disk was being emulated .
February 12, 20233 yr Community Expert 5 hours ago, ButchR said: Will I be able to use my unraid while the disk is being rebuild? Yes, performance will be slower though.
February 12, 20233 yr Community Expert Looks like a power/connection problem, check/replace cables and try again.
February 12, 20233 yr Author Okay. I power down and used another power connection to Disk #4. What steps next?
February 13, 20233 yr Community Expert Solution https://wiki.unraid.net/Manual/Storage_Management#Rebuilding_a_drive_onto_itself
February 13, 20233 yr Author Oh thank you very much. There was a few steps missing in the information I had at first. This wiki information covered the process a lot better.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.