I'm having an issue where today a drive shows a * for the temp and started showing a lot of errors. However the smart data is saying everything is ok.  I also had a drive that says it's ok that was removed from the array.  So I stopped the array, removed the "bad" drive, restarted the array, then stopped it again, then added the "bad" drive back, and started the array.  I formatted the drive and it then started a rebuild.  The rebuild (3rd screenshot) is showing the latest issue where it's saying it's done more rebuilding than what the drive is showing.   There is also the issue with drive 8 having tons of errors even though it's not displaying any reading/writing. The errors keep going up.  Is that because disk 10 is trying to take data from disk 8 and causing disk 8 to have errors? My drives are not making any weird noises so I'm unsure if there is perhaps a bad wire with one of them that is causing the other to show errors.  I've just stopped the array, removed disk 10, and restarted the array.  The results are now in the 4th screenshot.  The temp for drive 8 is now showing and it appears to functioning as intended. 

tower-diagnostics-20230215-2347.zip

Disk8 dropped offline and reconnected, cancel the rebuild, check/replace cables and try again.