March 16, 20233 yr Community Expert Just now, Neldonado said: Since parity rebuild is 25% complete should I let that finish before stopping/ checking cables? Probably best to let it finish. To scrub click on the first device of that pool and scroll down, it will sync up the dropped device.
March 16, 20233 yr Author Just now, JorgeB said: Probably best to let it finish. To scrub click on the first device of that pool and scroll down, it will sync up the dropped device. And what if this pool is just one device?
March 16, 20233 yr Author Hmm ok. Were you able to tell what happened with my first diagnostics yesterday? What are the next steps if the cables I just replaced are fine?
March 16, 20233 yr Community Expert If the disks continue to drop there's still a problem, and if it's not cables it could be PSU or controller.
March 16, 20233 yr Author So my parity rebuilds have never taken this long... it's been hovering around 20% since this morning... any reason to worry?
March 17, 20233 yr Author 5 hours ago, Neldonado said: So my parity rebuilds have never taken this long... it's been hovering around 20% since this morning... any reason to worry? no progress 2hrs later. Edit: it's been over 24 hours with no progress... what should I do? Edited March 17, 20233 yr by Neldonado
March 17, 20233 yr Community Expert Mar 16 19:56:49 Skynet kernel: md: sync done. time=82345sec Mar 16 19:56:49 Skynet kernel: md: recovery thread: exit status: 0 Parity sync finished some time ago, refresh the GUI, if using Firefox try a different browser, if it doesn't change reboot.
March 18, 20233 yr Author rebooted/ shut down server and went to replace the sata power splitters, found one with a bent / smashed pin. Culprit? IMG_0534.heic
March 18, 20233 yr Community Expert Could be, also those SATA splitters are usually a bad idea, especially if they are splitting a SATA plug, SATA should not be split for more than 2 disks, Molex can handle more.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.