March 15, 20233 yr Hello, After a long time of flawless performance, my Unraid became non responsive today. Its not accessible over network (IP address) and it did not output any signal to the monitor so I could not use command line. So it was shut down by the "red botton". I tried to read forums but did not find any other solution. When it boots up, the signal is back on the monitor and it shows the boot process. But at the end of this the signal to the monitor is again lost and I am not able to see the last stages... It shows up on the network but again is not accessible via IP. So I am lost, and not sure what to do... There was some options during booting (to choose safe mode - if I understood it correctly). But I don't want to manually shut it off and boot again until I get some feedback on how to proceed by the more knowledgeable members of this forum. Any help is much appreciated. Cheers, Kjetil Edited March 15, 20233 yr by Kjetil
March 15, 20233 yr Community Expert Does the monitor lose the image completely, like if nothing is connected?
March 15, 20233 yr Author The screen says "mode not supported", so it might be outputting something - but its never been like this before
March 15, 20233 yr Community Expert That usually means there's still output, are you booting normal or GUI mode? Also try with a different monitor if you have one.
March 15, 20233 yr Author Will test another monitor and feedback here. But always had signal to the screen before, and could access command line at any time. I think I am booting normal, it's just command line text that show up on the screen during booting. Its not like the GUI I have when accessing thru a web browser.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.