April 11, 20233 yr Hi guys, when my unraid run under 6.10.3, the eth0, NIC in board, worked properly. I updated my Unraid to 6.11.5, eth0 can not get ip, and cable light on board is NOT flashing. Then, i roll-back to 6.10.3, the etho worked again. Now i added one PCI-e NIC and can get IP address but cannot access to Community Applications . Is there anything i can do with my Unraid setting? home-diagnostics-20230411-1356.zip
April 11, 20233 yr Author 23 minutes ago, JorgeB said: There's no link detected on eth0, there is on eth1. I have plug on a cable on eth0. Under 6.10.3 eth0 was working, while under 6.11.5 eth0 wasnot working. I didn;t change any setting during the system update.
April 11, 20233 yr Community Expert eth0 is the main Unraid NIC, it must be connected/configured, if it's not working you can make eth1 > eth0, bottom of the network settings page, then reboot.
April 11, 20233 yr Author 1 hour ago, JorgeB said: eth0 is the main Unraid NIC, it must be connected/configured, if it's not working you can make eth1 > eth0, bottom of the network settings page, then reboot. thanks for your feedback eth1 is on a temporary useing pci-e NIC card, i prefer eth0 which is on bord. another porblem is when i use eth1, i can not access apps market/ docker update/ plugin udate
April 11, 20233 yr Community Expert 3 minutes ago, huapi said: i prefer eth0 which is on bord. OK, but that one will never work with no link detected.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.