TristanP Posted June 30, 2023 Share Posted June 30, 2023 (edited) I shutdown my unRAID machine to remove two unneeded disks and reroute cables. That went smoothly and the SAS controllers showed the right drives on the right interface. While booting it spit out the following: Quote Checking /dev/sda1 fsck.fat 4.2 (2021-01-31) There are differences between boot sector and its backup This is mostly harmless. Differences: (offset:original/backup) 65:01/00 Not automatically fixing this Dirty bit is set. Fs was not properly unmounted and some data may be lost Automatically removing dirty bit. /dev/sda1: 616 files, 92166/1874991 clusters mount: /dev/sda1 mounted on /boot. Verifying bzimage checksum ... Verifying bzroot checksum ... And there it sits. Pushing 30 minutes now. Any ideas what may be going on? Do I interrupt it or let it run. I am using unRAID v6.11.5. Thanks. Edited June 30, 2023 by TristanP Quote Link to comment
JorgeB Posted July 1, 2023 Share Posted July 1, 2023 Try redoing the flash drive. Quote Link to comment
TristanP Posted July 4, 2023 Author Share Posted July 4, 2023 (edited) I'll give it a shot. I thought the license was tied to some unique id on the USB stick though, So I downloaded the USB creator, created a new flash drive with the correct version (6.11.5) and copied the old /config folder onto the USB /config. Unfortunately it seems to have gotten worse. There are now dozens of listings after this text: Quote There are differences between boot sector and its backup This is mostly harmless. Differences: (offset:original/backup) instead of just the one prior. And there it sits. It's wondering what is going on that annoys me. Sigh Edited July 4, 2023 by TristanP Additional info Quote Link to comment
JorgeB Posted July 4, 2023 Share Posted July 4, 2023 I meant redo the same flash drive, if you use a different one you'll need to tranfer the key, but the new one should still boot. Quote Link to comment
TristanP Posted July 4, 2023 Author Share Posted July 4, 2023 Just to make sure: - Copy the /config directory off the flash drive - Use the unRAID USB creator to rewrite the 6.11.5 version back on the stick - Copy the /config directory back Sorry for being dense but before I do destructive operations I want to make sure I understand the process. Quote Link to comment
TristanP Posted July 4, 2023 Author Share Posted July 4, 2023 Did the above. No change from the new one. Here's a screen shot of the console (Wish I could get the entire output): Quote Link to comment
JorgeB Posted July 4, 2023 Share Posted July 4, 2023 If the same Unraid release booted before it suggests some hardware issue, I would start by resetting CMOS and removing any add-on cards and see if it boots like that. Quote Link to comment
TristanP Posted July 4, 2023 Author Share Posted July 4, 2023 Thanks for the suggestion. Now off to trial and error Quote Link to comment
TristanP Posted July 5, 2023 Author Share Posted July 5, 2023 Finally got time and puled the LSI SAS controller with no change. I them pulled the SAS Expander card (HP 468405-002) and disconnected it from the MB. Now I get a new error: Quote LZMA data is corrupt -- System halted That's after I redid the original USB with the latest unRAID writer (See above). Gotta admit....This is a new error for me. Quote Link to comment
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.