July 27, 20232 yr I'm coming from TrueNAS, and I feel a bit disoriented with Unraid. Here's my network setup: Unraid has two network interface cards (NICs): Marvel 2.5 Gbps connected to eth0 with IP address 10.0.0.1. Intel 10GB SFP+ connected to eth1 with IP address 10.0.0.2. I have an NFS share named "share1." The receiving end is a VMware ESXi box with a single Intel 10GB SFP+ NIC. I want to ensure that the NFS share only sends and receives traffic through the eth1 10GB NIC to improve transfer speeds. I suspect that there might be some 10GB tuning needed. I'm not using a cache drive, slog, or any additional setup. It's a straightforward setup with a single 850NVME drive over 10GB SFP+ to another 850NVME drive. In TrueNAS, I manually set some NFS share settings, including sync=disabled. The issue is that I can't find the same familiar options I used to see in TrueNAS on Unraid. Perhaps Unraid's configurations are primarily handled through config files. Can anyone point me to a guide me on how to properly configure the 10GB connection in Unraid
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.