I bought a new old server.  An HPE Proliant dl380 Gen10.  It came with 8 hard drives.  So far, I have only been able to see the same 4 drives.  I removed the working drives, added a new used LSI Raid card, and I cannot get these drives to work.  I see them listed in the system devices at the bottom under SCSI drives, but there is no size next to them.  Anyone have recommendations or experience with this?  I know the bays are fine.  The 4 working drives work in both the top and bottom bays.  I just cannot get these 3 drives to show up.  I did see them for a moment in the drive list, but they were embedded under one of the working drives.  When I deleted them to see if they would come back on their own, they did not.  There was no size on them at that point either.

 

SCSI Devices

[0:0:0:0]disk Generic- SD/MMC CRW 1.00 /dev/sda -

[1:0:0:0]disk SanDisk Cruzer Glide 1.00 /dev/sdb 30.7GB

[2:0:0:0]disk HGST HUS726060AL4210 ADD5 /dev/sdc -

[2:0:1:0]disk SEAGATE ST4000NXCLAR4000 GS22 /dev/sdd -

[2:0:2:0]disk HGST HUS726060AL4210 ADD5 /dev/sde -

[2:0:3:0]disk SEAGATE ST4000NXCLAR4000 GS22 /dev/sdf -

homeserver-diagnostics-20230728-1428.zip

Edited July 28, 20232 yr by tea_doe

Logical block size:   520 bytes

 

You need to re-format to 512B, look for sg_utils.