August 1, 20232 yr I don't know if it's related to the update from 6.11 to 6.12, I did a few days/1 week ago or so. But part of the dashboard will not show, the table, borders will show but not the data, I only have an unraid logo waiting forever. The server is still running, the dockers are running, etc.. just that the gui is not useful. After a reboot, everything looks good (at least when I did). It can be the docker page, the main page, the share pages, sometimes one can work but not the others. I don't think it's the same as this topic : I am already on IPv4 only and the gui is partially working in my case. I am trying to get the diagnostic, but when I download, it also seems unresponsive (or just take a lot of time), but the tools and setting pages were working.
August 1, 20232 yr Author 41 minutes ago, JorgeB said: If the issue happens right after boot try booting in safe mode. I didn't get the issue right after reboot. I also sometimes get a "bad gateway 502" on some page.
August 2, 20232 yr Author This is the diagnostic after doing a reboot to make it work. But the problem is not there. But my web gui isn't available with the proxy (nginx), getting 502 bad gateway, but all other dockers are fine. unraid-diagnostics-20230801-2109.zip Edited August 2, 20232 yr by Watever
August 2, 20232 yr Author Solution 16 minutes ago, Watever said: This is the diagnostic after doing a reboot to make it work. But the problem is not there. But my web gui isn't available with the proxy (nginx), getting 502 bad gateway, but all other dockers are fine. unraid-diagnostics-20230801-2109.zip 151.08 kB · 0 downloads For the proxy, the logs said couldn't renew the certificate. I renew the certificate throw nginx gui (the date was august 30th so should still be good) and it worked. Not sure why. I don't think that's the problem, but I will check if it comes back, since I rebooted. Unless someone see something in the diagnostic file. Could a parity check cause some problems too ? Edited August 2, 20232 yr by Watever
August 2, 20232 yr Community Expert You can enable the syslog server and post that after the problem to see if there's something visible there.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.