Dear all,

I change my mainboard and after pulll out some hdds now push in new sata ports, I can add them to array but data not show and  so would you please solve that problem for me.

Best regards,

 

unraid-diagnostics-20230902-1720.zip

Edited September 2, 20232 yr by airport

What controller were the disks using before?

Dear Sir, before adding that 3 hdd (4,5,6) can read data in new SATA mainboard , but when I add them to array it show that errrors.

Not sure I follow, are those disks new or did they already have data? If the latter

13 hours ago, JorgeB said:

What controller were the disks using before?

 

All disk have data and belong to one array before I pull it out of old mainboard

what board/controller?

Old board: Supermicor with LSI controller (run as Sata extend)

New board: Supermicro with sata on board

Most likely the LSI controller was in RAID mode, if parity is valid unassign one of the unmountable disks, start the array and post new diags.

7 hours ago, JorgeB said:

Most likely the LSI controller was in RAID mode, if parity is valid unassign one of the unmountable disks, start the array and post new diags.

Screenshot in first post shows no parity.

 

Would building parity after the fact work?

7 minutes ago, JonathanM said:

Screenshot in first post shows no parity.

Oops, missed that, that can only be done with valid parity.

 

See if the disks mount with UD if yes, transfer the data and reformat, if not you'll need to reconnect them with the old board.

I put only one hdd but can not read the data in that hdd, it show unmountable

15 minutes ago, airport said:

I put only one hdd but can not read the data in that hdd, it show unmountable

That won't help:

 

On 9/4/2023 at 4:44 PM, JorgeB said:

See if the disks mount with UD if yes, transfer the data and reformat, if not you'll need to reconnect them with the old board.

 

Dear Sir, I do not understand how to do "the disks mount with UD ". Regards,

Install the UD plugin and see if those disks mount with it.