September 10, 20232 yr My server is constantly crashing and running slow on me. I use the port 192.168.8.249 (static) and when I first turn on the server, it'll be running fine, I can load up any setting and docker. I've been trying to run a parity check for days now but after a bit of use, (it could be 3 minutes or 3 hours, it really just depends on how many times I switch from settings -> docker -> vm tab) it'll crash on me. Most of the time I'm stuck on the apps tab with nothing ever loading in, It I open a new tab (Firefox) it'll work then something else won't load. I then go to Microsoft edge and it'll work again for about a minute then the whole IP won't be reachable on anything and I have to hard reset to ever get it fixed. I left it in this state overnights and I still couldn't reach the IP the next morning. This is a brand new build and configuration, the only part I'm reusing from my old server is the Ethernet cable (since I know it works) and the USB (new config folder). I also have no dockers or VMs running, the open pluggins that I have are Unassigned devices, Community applications and Nvidia. Also, whenever I manage to run a partity sync it shows almost 5000 Sync errors corrected at around 3% done. Here are my parts CPU - I9-12900k 64GB G.SKILL DDR5 6000 PNY 4060 512 Inland 2.5 SSD (Secondary Cache) x2 WD Black m.2 nvme running in raid0 (Main Cache) x2 14tb Seagate EXO (manufacturers refurbished from serverpartdeals.com) 1000W PSU Gigabyte B650 MOBO excalibur-diagnostics-20230909-2222.zip Edited September 10, 20232 yr by heroic-barstool8121
September 10, 20232 yr Community Expert Solution Btrfs is detecting data corruption, start by running memtest.
September 11, 20232 yr Author 17 hours ago, JorgeB said: Btrfs is detecting data corruption, start by running memtest. Thank you so much, this never even crossed my mind since one of my 2 x 16 packs from microcenter was new and the other was used and I double checked with them that it was fully tested (half off so i thought it would be a good deal). After installing a memtest USB bootable one of the sticks failed after about 10 seconds which happened to be the open box one. Pretty annoying that if microcenter actually ram a memtest they would've noticed this but oh well... 2 hour drive for me tomorrow. Everything is booting up great now and very snappy.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.