September 28, 20232 yr picked up a new drive today and installed it and tried to start the preclear. when i start preclear it just sits at 0% done and current speed 0%. the dot to the left of the device is gray. it will let me try to format drive but it fails with in a few seconds of starting. is my drive bad? brand new WD sas 12tb plugged in to my sas controller card. my other 3 sas drives are working fine. there about 3 weeks old now. root@Patricks:~# smartctl -a /dev/sdc smartctl 7.3 2022-02-28 r5338 [x86_64-linux-6.1.34-Unraid] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Vendor: HGST Product: HUH721212AL5204 Revision: C9G0 Compliance: SPC-4 User Capacity: 12,000,138,625,024 bytes [12.0 TB] Logical block size: 512 bytes Physical block size: 4096 bytes LU is fully provisioned Rotation Rate: 7200 rpm Form Factor: 3.5 inches Logical Unit id: 0x5000cca2b099a784 Serial number: 5QJRHMUB Device type: disk Transport protocol: SAS (SPL-4) Local Time is: Wed Sep 27 18:10:52 2023 PDT device Test Unit Ready [medium or hardware error (serious)] A mandatory SMART command failed: exiting. To continue, add one or more '-T permissive' options. root@Patricks:~# logs.txt Edited September 28, 20232 yr by patrickvol new info
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.