October 5, 20232 yr I am a complete unraid novice, so I'll start with that. When I boot up the system, the webGUI works fine, until I start the array. Once the drives are mounted, the webGUI becomes completely unreachable. I can get it back by killing rc.samba and then starting rc.nginx. I went ahead and turned off SMB (which in turn stopped my automated backups) and rebooted, but had to kill rc.samba to get rc.nginx going again. I know it's possible to have both running, but I have zero idea of where to make any changes so that I can stop having to do this. Thanks in advance. diagnostics-20231005-0737.zip Edited October 5, 20232 yr by brooksbeebe Change diag file name
October 5, 20232 yr Community Expert Do you have the same issue after booting the server in safe mode? If yes post new diags.
October 5, 20232 yr Author 19 minutes ago, JorgeB said: Do you have the same issue after booting the server in safe mode? If yes post new diags. Booting in safe mode doesn't mount the drives though. It's something specifically tied to mounting the drives/starting dockers. Before the drives are mounted, I have completely free reign to do whatever I want. Once the drives mount though, the rc.samba party starts and the rc.nginx party is over. I don't have the issue in maintenance mode and I don't have the issue before the array is started. I did have a windows 10 vm that had a network drive tied back to the array, which is where this issue started. I have since deleted that vm and erased the disk to see if that would resolve the issue to no avail. Edited October 5, 20232 yr by brooksbeebe
October 5, 20232 yr Community Expert 1 hour ago, brooksbeebe said: Booting in safe mode doesn't mount the drives though. It does.
October 5, 20232 yr Author 2 minutes ago, JorgeB said: It does. Didn't know that. Ok...it might be this evening before I can do that, but I'll get it booted into maintenance mode and post the diags.
October 5, 20232 yr Author 1 hour ago, JorgeB said: It does. Ok, so I stopped the array to boot into maintenance mode, and the webgui became inaccessible. Restarting nginx did not help. Rebooted...got the GUI back...working on getting the diagnostics now. maintenancemode-diagnostics-20231005-1049.zip Edited October 5, 20232 yr by brooksbeebe added maintenance diags
October 5, 20232 yr Community Expert 2 hours ago, brooksbeebe said: to boot into maintenance mode I asked to try safe mode.
October 5, 20232 yr Author 37 minutes ago, JorgeB said: I asked to try safe mode. Ah. Didn't realize there was a difference. My apologies. Will try that and report back.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.