During the early hours of this morning my neighbourhood lost power. It came back up a few hour later but while booting my server it dropped out again and didn't come back up for another couple of hours after that. I waited a while to make sure it didn't drop out again, then booted my server. I left it about 20 mins while I grabbed a drink and then attempted to access the WebUI. Across a few devices I was unable to load the Unraid Web UI instead receiving a "Err_Connection_Refused" response in Edge and Chrome. I immediately pinged the machine and got a response, next up I tried SSH, was able to connect without issue and figured maybe just a bad boot. I issued a 'powerdown' command and gave it a minute or two before powering back up. After boot, same issue.

 

TL;DR - After power outage:

WebUI - Not working

SMB - Not working

Local Access CMDline - Working

Local Access GUI - Notworking

SSH (Over any IP assigned) - Working

 

Things Ive tired:

Removing any stored config on my PFsense Router (Clearing DHCP Leases and such)

Removed Network Config from Unraid in effort to "Reset" networking

Booting with GUI, only to receive a flashing '_' 

Booting to Safe Mode without GUI and with GUI receiving same results as other options

Connected by SSH and ran Diagnostics (attached)

 

Any ideas what could be the issue or any other information that would be helpful?

draig-diagnostics-20231118-0529.zip

If safe mode didn't help try booting with a different flash drive using a stock Unraid install, no key needed, just to see if it's a config issue.