December 22, 20232 yr Hi! it's the first time I'm using Unraid and My Parity-Sync is estimated for 4 days with a speed of 36.2 MB/sec. Is it normal? Edited December 22, 20232 yr by papalegba
December 22, 20232 yr Author No problem Thank you! vodou-diagnostics-20231222-1505.zip Edited December 22, 20232 yr by papalegba
December 22, 20232 yr Author 4 minutes ago, trurl said: USB not recommended for array or pools for many reasons Thank you the information. I was trying to use it with a NUC and I didn't know it was a bad idea.
December 22, 20232 yr Community Expert Are you trying to do the initial data load and build parity at the same time? That would cause a lot of thrashing of disk heads even if these were SATA disks. Best if you don't try to write a lot of data during parity sync or parity check. Fastest is to not assign parity until initial data load is complete, then let parity sync.
December 22, 20232 yr Author 4 minutes ago, trurl said: Are you trying to do the initial data load and build parity at the same time? That would cause a lot of thrashing of disk heads even if these were SATA disks. Best if you don't try to write a lot of data during parity sync or parity check. Fastest is to not assign parity until initial data load is complete, then let parity sync. Hmmm I'm not sure. I choosed the parity drive , the array , the m.2 for the cache and I clicked on start.
December 22, 20232 yr Community Expert 5 minutes ago, papalegba said: I'm not sure Are you writing data to the server while it is doing parity sync? Simple as that.
December 22, 20232 yr Author 7 minutes ago, trurl said: Are you writing data to the server while it is doing parity sync? Simple as that. no nothing just waiting.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.