January 10, 20242 yr Hi, I've been using unRAID for 4 years now, and it's been great until 6.12. I'm currently on 6.12.6, and my server keeps on randomly crashing on me. I end up losing access to the web GUI, but the server is still on with the fans spinning. My most recent incident had the web gui booted and once it finally crashed (takes around 10-12 hours each time). Even with the web gui I had a static image that was suck and my mouse could not move. The only fix is to hard reset by holding the power button down. Has anyone experienced this and has a fix? I attached some logs and diagnostics vader-diagnostics-20240109-1804.zip vader-syslog-20240110-0212.zip
January 12, 20242 yr Author Thank you. Waiting on it to fail again. I'll respond when it does. I turned on syslogs and am having them write to the OS USB flash drive (temporarily until i get the logs I need) Edited January 12, 20242 yr by rum-z
January 12, 20242 yr Author Sys logs attached. This time I turned off the server gracefully. It did not lock up. However, 5 min after I turned it off, the server was still "on" with fans spinning and LEDs inside the case on. Yet I couldn't access the web gui. syslog
January 12, 20242 yr Community Expert Solution The syslog shows that you have docker set to use macvlan AND have bridging enabled on eth0. As mentioned in the Release Notes this combination is know to cause system crashes. You ether need to disable bridging on eth0 or switch docker to using ipvlan networking.
January 13, 20242 yr Author Thank you. I turned off bridging on eth0. I'll give it a few days and then mark the issue as resolved
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.