Hello,

Few days back I added a Nic 10G in my Unraid NAS REf: KALEA-INFORMATIQUE Carte contrôleur réseau PCIe 3.0 x8 LAN Ethernet 10G 2 Ports RJ45. avec Chipset Intel X540.

 

I rebooted and no issue during 2 days. Then I had to reboot after some changes, &  have 2 disks with message DEVICE IS DISABLED...

I replace one of them by another one then rebuild , then i rebuilt on it the second . Were all green and after  reboot they are back again to disabled...

I replaces sata concerned and power split by direct connection to the power.

I tried twice to rebuild them but always bask to same issue after a reboot.

NIC 10G works fine.

 

I'll attach the last diag . Disks concerned are sdk & sdl

Thanks a lot in advanced for your help, i'm disapointed and afraid another disk could fail.

 

 

basilix-diagnostics-20240111-2146.zip

On your Windows11 Delphine VM you are passing throught a SATA controller, device IDs usually change you you add new hardware, so you need to adjust.

Thanks Jorge for your feedback. I'll have a look.  But for this moment VM & dockers are stopped , does it impact really the Big Array?

 

Yesterday i replace one disk by a new one , and after rebuilt & reboot i have same disk issue with this new disk.

 

I attach the new diagnostic (sdk new disk )  .

At the work actually i'll check when i return to home according what you said .

 

 

 

 

Finally i connected in remote and remove the controller for the VM.

I did a reboot. but disks are always disabled. Do i have something else to do please?

 

again many thanks.

Franck

Last Diag if helpfull:

basilix-diagnostics-20240112-1108.zip

1 hour ago, FFranck said:

I did a reboot. but disks are always disabled

After the disks get disabled you need to rebuild them, just rebooting won't do anything.

Rebuild means resync right?

Resync usually means parity, disks we use rebuild, but it means the same.

Hello Jorge,

I took too much time to answer but i want to be sure all is fine.

Thanks a lot . I appreciated your help.

Franck