January 22, 20242 yr Hi Everyone, been a while since I have had a problem, appreciate any help. My motherboard failed, replaced with Aus Z170 Pro Gaming and installed 2x LSI 9200 8e and 1x LSI 9200 8i controllers from original setup. All been flashed many years ago to 20.00.07.00-IT Message I am getting is Adapter configuration may have changed, reconfiguration is suggested. So I Ctr C into the configuration tool. What setting should the Boot support be? Enabled BIOS and OS? Enabled BIOS only? Enabled OS only? Disabled? All drives are correctly identified for all 3x 9200's When I boot to UnRaid I do see all the drives, 24 of them, 2x Parity and 22 data drives, I have 1x red X which was from before the motherboard failure. Just want to be sure I do not have an issue if I replace the drive and rebuild from parity. I can fire up the UnRaid and get Diagnostics if needed, let me know. Much appreciated Steve Edited January 23, 20242 yr by HK-Steve
January 22, 20242 yr 16 minutes ago, HK-Steve said: What setting should the Boot support be? Enabled BIOS and OS? Enabled BIOS only? Enabled OS only? Disabled? It doesn't really matter, you don't even need a BIOS installed on the HBAs to use them with Unraid.
January 22, 20242 yr Author Set to disable. Thanks JorgeB Attached Diagnostic file. All seems ok, other than the failed disk, strangely disk 6 said it's temp was 87'c which it was not......... But another set of eyes to check would be appreciated Cheers tower2-diagnostics-20240122-1813.zip
January 22, 20242 yr 13 minutes ago, HK-Steve said: strangely disk 6 said it's temp was 87'c which it was not......... Yep, that doesn't look right: Current Temperature: 88 Celsius Power Cycle Min/Max Temperature: 83/88 Celsius Lifetime Min/Max Temperature: -127/127 Celsius Firmware issue? Everything else looks OK to me so far.
January 22, 20242 yr Author Awesome, much appreciated. I will replace the failed drive then the over temp drive. I know I could do both at once with 2x parity, but that is just me........ These drives are not young..... 😁
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.