I have had to reboot my server multiple times due to network reconfiguration. I finally manged to configure the network, but could see the array would not start, and was trying to start indefinetly. 

I've turned off autostart and booted in safe mode. I am able to start the array and all shares work and so on. But still blank main screen.

 

I am on version 6.12.6

 

I have attached diagnostics.

I suspect i may have booted while trying to mount a disk, but i do not know what to do.

Please if anybody can help. Thank you.

chl-unraid-01-diagnostics-20240215-2109.zip

Are you able to grab the diagnostics when starting normally?  Or via safe mode, enable the syslog server (mirror to flash) and then reboot into the normal mode and finally after attempting to start grab the syslog file from the /logs folder on the flash drive and attach it here

 

So what i ended up doing is booting to GUI MODE and to my surprise i could see all the arrays from there. What i noticed is when accessing directly from "console output" in GUI MODE it's connecting via localhost. I've noticed that there were no SSL warning when doing so. 

So i went back to accessing via IP, deleted the certificate under Management Access. Provisined a new certificate and enabled SSL/TLS.

 

Somehow SSL/TLS was disabled. I am not sure how since i didn't tinker with anything else than the network settings.