March 8, 20242 yr I had a disk fall off Power issue or something like that when i went to remove and replace the disk as you do following the directions in the forums. I ended up with two dries that did not want to play nicely. I eventually got the rebuild working after a few try (disk errors), the rebuild finished 100% no errors on the array. but instead of showing the emulated drives it show unmount able with a green dot. what should i do next? Diag from post good rebuild but unmountable drives. 3/5 prime-diagnostics-20240305-1122.zip
March 8, 20242 yr Community Expert Check filesystem on disks 2 and 6, run it without -n, and if it asks for -L use it.
March 8, 20242 yr Author on drive 2 i got this message at the end: disconnected dir inode 17179869343, moving to lost+found Phase 7 - verify and correct link counts... resetting inode 134 nlinks from 2 to 5 Note - stripe unit (0) and width (0) were copied from a backup superblock. Please reset with mount -o sunit=,swidth= if necessary done Do i run this agin with -o ?
March 8, 20242 yr Community Expert Solution Should not be needed, and -o is for the mount command, not xfs_repair, just see if it mounts now.
March 8, 20242 yr Author they both mount now. What is recommended to move the Lost and found data back to the correct share folders.
March 8, 20242 yr Community Expert There's no automatic way, you basically need to try and sort the files.
March 8, 20242 yr Community Expert You may find the linux 'file' command useful if you need to work out the type of any file in Lost+Found
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.