March 20, 20242 yr Quote [ 35.137085] mpt3sas version 43.100.00.00 loaded [ 35.142757] mpt3sas 0000:02:00.0: Unable to change power state from D3cold to D0, device inaccessible [ 35.145612] mpt3sas_cm0: 63 BIT PCI BUS DMA ADDRESSING SUPPORTED, total mem (131751380 kB) [ 35.148455] mpt3sas_cm0: sending diag reset !! [ 35.306701] mpt3sas_cm0: Invalid host diagnostic register value [ 35.309552] mpt3sas_cm0: System Register set: [ 35.394976] mpt3sas_cm0: diag reset: FAILED [ 35.395513] mpt3sas_cm0: failure at drivers/scsi/mpt3sas/mpt3sas_scsih.c:12348/_scsih_probe()! A bit of a botched upgrade, I was replacing a PLX M.2 card as my board doesn't support bifrucation but a new HBA card had the wrong cables. When I tried to reinstall the PLX card again my system just refused to boot. Tried bios upgrades, etc but its stuck. Now I've decided to temporarily run on a SATA SSD for cache but disaster... unraid can no longer see my drives! The drives are all listed in my bios (22 + 1 SSD + 3x M.2), but I've had no luck trying to get UNRAID to see them. The controller in question is seen but throwing errors: [1000:00c4] 02:00.0 Serial Attached SCSI controller: Broadcom / LSI SAS3224 PCI-Express Fusion-MPT SAS-3 (rev 01) Any suggestions? beyonder-nas-diagnostics-20240320-0255.zip Edited March 20, 20242 yr by scs3jb
March 20, 20242 yr Community Expert Solution Try a different PCIe slot if possible, you can also try the bellow, though not sure it helps with this error: https://forums.unraid.net/topic/132930-drives-and-usb-devices-visible-in-bios-not-available-once-booted-asus-wrx80-sage-5965wx/?do=findComment&comment=1208035
March 20, 20242 yr Author 1 hour ago, JorgeB said: Try a different PCIe slot if possible, you can also try the bellow, though not sure it helps with this error: https://forums.unraid.net/topic/132930-drives-and-usb-devices-visible-in-bios-not-available-once-booted-asus-wrx80-sage-5965wx/?do=findComment&comment=1208035 I went through so many iterations of head scratching with the two cards, seems that I forgot that the X13SAE-F only supports single cards in slot 7 (CPU) because of some crazy switching (Slot 4 and Slot 7 both need to be occupied for 8x, or a single 8x must be in slot 7). Thanks as always!
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.