I have had this translated from German into English by deepl

Unfortunately I can no longer find my way around, I have already searched for a lot here in the forum but have not found anything.
therefore I ask for help today

 

My system with a raid controller and AMD 3800x and 48 GB Ram has the problem that it always stops the hardware is still running but I can no longer access the SMB or VM or web interface.

 

I have already tried the older version of Unriad and now the latest version but unfortunately it still does not work.

 

I would like to provide you with logs but unfortunately I can't find them.

 

Thanks from me Zodiac

 

 

Modell:Custom

M/B:Micro-Star International Co., Ltd B450-A PRO MAX (MS-7B86) Version 4.0 S/N K416699735

BIOS:American Megatrends Inc. Version M.70 Datiert 06/17/2020

CPU:AMD Ryzen 7 1800X Eight-Core @ 3000 MHz

HVM:Aktiviert

IOMMU:Aktiviert

Cache:L1 - Cache: 768 KiB, L2 - Cache: 4 MiB, L3 - Cache: 16 MiB

Arbeitsspeicher:48 GiB DDR4 (Maximal installierbare Kapazität 128 GiB)

Netzwerk:bond0: fault-tolerance (active-backup), mtu 1500

Kernel:Linux 6.1.79-Unraid x86_64

OpenSSL:1.1.1v

Make sure this has been taken care of:

https://forums.unraid.net/topic/46802-faq-for-unraid-v6/?do=findComment&comment=819173

 

I have had this translated from German into English by deepl

 

Thanks for your tip I'll have a look at it tomorrow and do everything but I still had a question I had my CPU clocked down to 3ghz. So that it is a bit more power saving and in the previous versions I had no problem with the problem I have since 6.12.6. But as I said thank you for your help and I will do what you wrote there.
Thank you

I have had this translated from German into English by deepl

 

 

Moin I thank you again for your help but I have now tested everything including what you have suggested to me and it still goes out after a while I have even reinstalled Unraid. I think motherboard or CPU are Kapput Because I have tried 2 CPU once an 1800x and once 3200g and the systeam does not start when I tack the ram to 3200 I assume that the ram controlle is defective or the ram links on the board are defective.

Translated with www.DeepL.com/Translator (free version)