Skip to content
View in the app

A better way to browse. Learn more.

Unraid

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Unresponsive in middle of rebuild required reboot

Featured Replies

I am currently doing a rebuild on a larger 16TB drive from an older 8TB drive.  Everything was going smoothly for around 50% then it became unresponsive to both webGUI and GUI directly connected.  I could still ping the server but SSH into it was not working either.

 

Attached are diagnostic logs from right after the reboot.

 

Thanks everyone!

milkyway-diagnostics-20240716-0233.zip

Solved by JorgeB

  • Community Expert
  • Solution

Looks like NIC issues, are you using a USB NIC?

 

Jul 16 00:46:07 MILKYWAY kernel: r8152-cfgselector 4-4: reset SuperSpeed USB device number 2 using xhci_hcd
Jul 16 00:46:07 MILKYWAY kernel: r8152 4-4:1.0 eth0: Promiscuous mode enabled
Jul 16 00:46:26 MILKYWAY kernel: BUG: Bad page state in process update_3  pfn:334200

 

  • Author

I am, and I am also using a kvm that has a USB component that plugs into USB. Is there any chance that caused the issue? My problem with the nic is that I don't have enough slots and lanes on the motherboard to go with an internal 2.5gbe nic. 

 

Should a USB nic be fine or do they historically cause these kind of problems? If I were to remove something to make space for an internal nic are there any 2.5gbe that come highly recommended? 

 

Thank you! 

  • Community Expert

I would use the onboard NIC temporarily to confirm if that is the problem or not.

  • Author

Ok, so I just had another crash.  Luckily the rebuild was completed so I didn't have to worry about restarting that.  Here are the latest diagnostics.  I am hoping it will show the same issue with the network so that I can start isolating it to that.  I will switch to only the internal NIC and see if I get any more of a solid run time.  Any good reccomendatiosn for an internal unraid NIC that is 2.5gbe?

 

Thanks again!

milkyway-diagnostics-20240718-1608.zip

  • Community Expert
8 hours ago, Rhuarc said:

I am hoping it will show the same issue with the network so that I can start isolating it to that.

It does.

 

8 hours ago, Rhuarc said:

Any good reccomendatiosn for an internal unraid NIC that is 2.5gbe?

Both the Intel and Realtek 2.5GbE NICs are supported, but Intel is usually better.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.