I am trying to use this board for my very first unraid build. http://reviews.cnet.com/motherboards/intel-server-board-se7210tp1/4507-3049_7-30828369.html?tag=mncol;subnav

 

I've got it all booted up and it recognized the onboard SATA (though SATA cards are being a pain in the butt) and the 100mb LAN, but the Gigabit is not working.  Is there any way to get it working or am I going to have to get an add on Gigabit card?

 

System log attached below.

 

root@mongo:~# ethtool eth0
Settings for eth0:
        Supported ports: [ TP MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
        Advertised pause frame use: Symmetric
        Advertised auto-negotiation: Yes
        Link partner advertised link modes:  10baseT/Half 10baseT/Full
                                             100baseT/Half 100baseT/Full
        Link partner advertised pause frame use: Symmetric
        Link partner advertised auto-negotiation: Yes
        Speed: 100Mb/s
        Duplex: Full
        Port: MII
        PHYAD: 1
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: g
        Wake-on: g
        Current message level: 0x00000007 (7)
        Link detected: yes
root@mongo:~# ethtool eth1
Settings for eth1:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: No
        Advertised auto-negotiation: Yes
        Speed: Unknown!
        Duplex: Unknown! (255)
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        MDI-X: Unknown
        Supports Wake-on: umbg
        Wake-on: g
        Current message level: 0x00000007 (7)
        Link detected: no

syslog.txt

either disable eth0 in the BIOS, or

configure/enable eth1 in the config/go script.

 

Joe L.

That worked perfectly!  Thanks!  I just disabled the 100mb in the mother board bios.  I don't know why I didn't consider the fact that the 100mb jack might be taking preference over the 1000mb jack.