I replaced a 1TB with a 2TB, after passing pre-clear and replaced disk7. Now, disk3 has red balled. Powered down, checked all the cables and then when I ran the SMART report and get Smartctl: Device Read Identity Failed (not an ATA/ATAPI device) as a reply.

 

This shows up in the syslog repeatedly.

Jan 31 17:17:39 Asgard kernel: ata13: status=0x51 { DriveReady SeekComplete Error } (Errors)
Jan 31 17:17:39 Asgard kernel: ata13: error=0x04 { DriveStatusError } (Errors)

 

I'm guessing disk3 somehow died during the rebuild?

 

My syslog is 4MB and I'm not sure what to take out, so I'm just going to link to it:

http://www.twinsen.org/upload/syslog-1-31-2012.txt

http://www.twinsen.org/upload/smart.txt

 

I am getting the same exact errors, I would be very interested in helping resolve this, anyone have any ideas?

 

Thanks!

Disk3 has died and needs to be replaced.

Thank you very much for the reply, I will start in on a RMA.

Yep, that's what I ended up doing...couldn't wait for the replacement though and had to cough up $140 :'(

Are you talking about the Advance Exchange? Or did you end up buying another drive? If you (like me) did the Advance Exchange that just means that they put a hold on your card until the get a process the failed drive, they don't actually charge you unless you don't send the drive back in, within 30 days.

I just bought another drive. I just couldn't wait for the week turn-around time and I only had spare 1TB drives.