September 12, 20241 yr hello unraiders, i have a lot of parity sync errors for months now after removing my hbacard and using my motherboard sata ports. i run parity sync first with out Correcting Parity Check On with a lot of errors after its was finished and now its running with Correcting Parity Check On but still having ther errors ( its still running ) i did change twice the sata cables but it has no effect. parity check done without Correcting Parity Check On what can i do ? or should i rebuild the parity with new config? Regards sarnas-diagnostics-20240912-1942.zip
September 12, 20241 yr Community Expert If the first check was not correct, the 2nd one will find the same errors, run another one after the correcting check finishes.
September 12, 20241 yr Author 52 minutes ago, JorgeB said: If the first check was not correct, the 2nd one will find the same errors, run another one after the correcting check finishes. thanks for the reply. i will do after its finishes should it be without Correcting Parity Check On?
September 12, 20241 yr Community Expert Solution 38 minutes ago, mrfly said: will do after its finishes should it be without Correcting Parity Check On? It should be irrelevant because after running a correcting check the next one should show 0 errors if you have no underlying problem. My recommendation would be to always use a non-correcting check unless you expect there to be errors that need correcting.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.